Injection-Moulded Seals & O-Rings
Injection-moulded seals, gaskets and O-rings in elastomers and engineering plastics, produced in the colour and hardness specified.
View specificationsDetails
Plastic & Injection Parts
Injection-Moulded Clamps & Brackets
Injection-moulded pipe clamps, saddles and mounting brackets, moulded with the fixing detail already in the part.
| Part weight | 1 g – 15 kg |
|---|---|
| Mould life | Typically 200 000 – 500 000 shots per tool, by material and geometry |
| Dimensional | ±0.2 mm general, shrinkage compensated into the tool |
About this part
What it is and why it is made that way
Moulding the fixing detail into the part removes the separate bracket, the screws and the assembly time. These clamps and saddles carry the pipe or tube, and the mounting foot, slot or hole is part of the mould rather than something welded or screwed on afterwards. Where a rubber liner is needed, it is moulded in as a separate part.
- Fixing foot, slot or hole moulded into the part
- Cradle geometry matched to the pipe or tube diameter
- Optional rubber liner moulded separately
- Snap-fit and screw-clamp styles
Materials
- ABS and ABS/PC
- Nylon PA6 / PA66
- POM (acetal)
- PP and PE
- PVC-U
- Silicone and TPE
Production processes
- Injection moulding
- Overmoulding
- Insert moulding
- Compression moulding
- Silicone moulding
- Two-shot moulding
Typical applications
- Pipe and tube clamping
- Cable and conduit support
- Panel mounting
- Fluid line retention
Specification
Technical detail
The ranges below are what this shop typically holds. Anything tighter than the baseline is possible — send the drawing and we will confirm it against your specific tolerances rather than quote from a table.
| Part weight | 1 g – 15 kg |
|---|---|
| Mould life | Typically 200 000 – 500 000 shots per tool, by material and geometry |
| Dimensional | ±0.2 mm general, shrinkage compensated into the tool |
| Colour | Natural, black, white or custom Pantone — minimum order quantity applies |
| Tooling | Aluminium or steel mould; T1 lead time quoted per project |
| Bore | To the specified tube OD, ±0.1 mm |
| Mounting | Slot, keyhole or screw hole, to specification |
| Material | ABS, PA66, POM or PVC-U, to environment |
Material and finish are yours to choose. The lists above are the families this part is normally made in. We will not substitute a grade or change a tolerance without telling you first — and asking.
In the same process line
Other Plastic Parts parts
If this is not quite your part, these are made on the same equipment with the same inspection.
Custom Gaskets & Sealing Rings
Flat gaskets and moulded sealing rings cut or moulded to the flange geometry, with the bore and outer diameter held to drawing.
View specificationsDetails
Rubber Bellows & Suction Boots
Moulded rubber bellows and suction boots that protect a moving joint from dust, coolant and impact.
View specificationsDetails
Get a quote for this part
Send the drawing and we will quote it against your material, your tolerance and your quantity. One business day, in writing, with a lead time you can plan around.