Injection-Moulded Seals & O-Rings
Injection-moulded seals, gaskets and O-rings in elastomers and engineering plastics, produced in the colour and hardness specified.
View specificationsDetails
Plastic & Injection Parts
Injection-Moulded Pipe Fittings
Injection-moulded elbows, tees and reducers in ABS and PVC-U, moulded with the specified wall thickness and socket depth.
| Part weight | 1 g – 15 kg |
|---|---|
| Mould life | Typically 200 000 – 500 000 shots per tool, by material and geometry |
| Dimensional | ±0.2 mm general, shrinkage compensated into the tool |
About this part
What it is and why it is made that way
Moulded fittings are dimensionally consistent in a way that a machined or fabricated fitting is not, which makes them the right choice for a fluid system that has to be assembled and then dismantled many times. This line covers elbows, tees and reducers in ABS and PVC-U, moulded with the wall thickness and socket depth specified.
- Moulded in ABS, PVC-U or a specified compound
- Socket depth held to the specified dimension
- Wall thickness controlled throughout, not only at the nominal points
- Pressure and leak tested on request
Materials
- ABS and ABS/PC
- Nylon PA6 / PA66
- POM (acetal)
- PP and PE
- PVC-U
- Silicone and TPE
Production processes
- Injection moulding
- Overmoulding
- Insert moulding
- Compression moulding
- Silicone moulding
- Two-shot moulding
Typical applications
- Fluid handling lines
- Pneumatic distribution
- Water and chemical handling
- Laboratory and plant services
Specification
Technical detail
The ranges below are what this shop typically holds. Anything tighter than the baseline is possible — send the drawing and we will confirm it against your specific tolerances rather than quote from a table.
| Part weight | 1 g – 15 kg |
|---|---|
| Mould life | Typically 200 000 – 500 000 shots per tool, by material and geometry |
| Dimensional | ±0.2 mm general, shrinkage compensated into the tool |
| Colour | Natural, black, white or custom Pantone — minimum order quantity applies |
| Tooling | Aluminium or steel mould; T1 lead time quoted per project |
| Socket depth | To the specified schedule, ±0.5 mm |
| Wall thickness | Controlled to the nominal ±10% |
| Test | Pressure or leak test available on request |
Material and finish are yours to choose. The lists above are the families this part is normally made in. We will not substitute a grade or change a tolerance without telling you first — and asking.
In the same process line
Other Plastic Parts parts
If this is not quite your part, these are made on the same equipment with the same inspection.
Custom Gaskets & Sealing Rings
Flat gaskets and moulded sealing rings cut or moulded to the flange geometry, with the bore and outer diameter held to drawing.
View specificationsDetails
Rubber Bellows & Suction Boots
Moulded rubber bellows and suction boots that protect a moving joint from dust, coolant and impact.
View specificationsDetails
Get a quote for this part
Send the drawing and we will quote it against your material, your tolerance and your quantity. One business day, in writing, with a lead time you can plan around.