Forged Flange Hubs
Forged steel flange hubs with a raised pilot boss, produced closed-die and finish-machined to suit the mating shaft.
View specificationsDetails
Forging Parts
Forged Pins & Shaft Parts
Forged dowel pins, cross pins and shaft components, finish-turned with controlled diameter and concentricity.
| Forging weight | 0.5 – 25 kg per part, per die set |
|---|---|
| Tolerance | ±1.5 mm as-forged; finished to ±0.05 mm after machining |
| Heat treatment | Quench and temper, normalising or annealing — to specification |
About this part
What it is and why it is made that way
Pins and dowels look simple but they locate assemblies, so their diameter and concentricity have to be controlled. Forging gives them the strength to carry the shear load and the internal quality to resist breaking under assembly load. They are finish-turned and, where the drawing calls for it, ground.
- Forged for shear strength and internal soundness
- Finish-turned to the specified diameter
- Hardened pins available for wear applications
- Supplied individually, in sets, or matched to a bore manifest
Materials
- C45 / 40Cr carbon steel
- 42CrMo alloy steel
- 20CrMnTi / 20CrMnMo gear steel
- Stainless 304 / 17-4PH
- Alloy steel 40CrNiMoA
Production processes
- Open-die forging
- Closed-die forging
- Hot and cold forging
- Heat treatment
- CNC finish machining
Typical applications
- Hinge and linkage pins
- Dowel pins and location dowels
- Cross pins
- Pivot and locking pins
Specification
Technical detail
The ranges below are what this shop typically holds. Anything tighter than the baseline is possible — send the drawing and we will confirm it against your specific tolerances rather than quote from a table.
| Forging weight | 0.5 – 25 kg per part, per die set |
|---|---|
| Tolerance | ±1.5 mm as-forged; finished to ±0.05 mm after machining |
| Heat treatment | Quench and temper, normalising or annealing — to specification |
| Material certification | Mill test certificate available on request |
| Forging ratio | Up to 4:1, per die set |
| Pin diameter | Ø8 – Ø120 mm |
| Diameter tolerance | h7 / h9, or as specified |
| Hardness | Case-hardened or through-hardened on request |
Material and finish are yours to choose. The lists above are the families this part is normally made in. We will not substitute a grade or change a tolerance without telling you first — and asking.
In the same process line
Other Forging parts
If this is not quite your part, these are made on the same equipment with the same inspection.
Forged Ring Flanges
Forged ring flanges with a full-length sealing face, machined flat and parallel for a reliable gasket line.
View specificationsDetails
Forged Bolt-Circle Flanges
Forged flanges with a dense bolt-hole circle, machined and faced for high-pressure bolted connections.
View specificationsDetails
Get a quote for this part
Send the drawing and we will quote it against your material, your tolerance and your quantity. One business day, in writing, with a lead time you can plan around.